Front QA1 DS401 double adjustable Coil over shockabsorbers fitted in place.

As you can see I have 400lb 9" length springs shown. 
I have since swapped these springs to 550lb 10" length springs.




Shocks all fitted in place, as we did to the rear shocks, spacers have to be made up on the top pivot to keep shocker eye central in the chassis bracket. I made them from stainless steel half inch tube. The bottom has a special bush supplied with the shocks that is pressed in the lower eye that is shown in a pic above. This connects to the lower bolt with the sway bar. Shock lower pivot, sway bar and lower control arm all clamps together when the bolt is tightened. No spacers needed for the lower pivot.

No comments:

Post a Comment